Prevent switch, socket fire to install smoke alarm in time

    Nowadays, the improvement of living standards has entered the age of automation and electricity. "electricity" has provided many conveniences for people´s work and life, mainly in the popularization and application of various household appliances. Household appliances are mainly powered by switches and sockets, so the use of switches and sockets is very high. However, if the switch and socket are selected, installed or used improperly, it is easy to cause fire accidents and remind everyone to install smoke alarm. The following is the method of preventing switch and socket causing fire.

1. Select the right switch and socket according to the total capacity and specific environment of household appliances. High humidity places should choose fire control switch and pull switch; The indoor uninstall switch and outlet that have corrosive article or dirt is bigger, but should be installed outdoors; The place that has burning, explosion danger, should choose fireproof or explosion-proof switch and outlet.

The rated current and rated voltage of the switch and socket shall be in accordance with the actual power consumption. Do not overload the line, so as to avoid the line overload and burn the bakelite to cause a fire.

3. The knife switch should be used to match the fuse. It is not allowed to make any changes, especially in the thick melt, and not to replace the fuse with copper, aluminum, iron and other metal wires.

The single-pole switch shall control the fire (phase) line and not be connected to the zero line. Otherwise, contact with human body can cause electric shock. Once the wire is grounded, a short circuit or even a fire can occur.

5. The socket of the lamp socket is prone to accidents when overloaded. Therefore, electric irons, electric furnaces, air conditioners and other high-power electrical appliances should not be used in the socket outlet to avoid causing fire.

6. After the switch and socket are aged and damaged, they should be repaired and replaced in time.

7. When going out, sleeping or sudden power failure, it is necessary to cut off the power supply in time, especially the electric heating appliance.

8. The switch and socket should be installed in a dry, clean and clean place, so as to avoid the fire caused by the corrosion of the rubber wood.