News Industry News Details
Industry NewsPay attention to fire prevention during the epidemic to install intelligent smoke alarm gas alarm
Time: 2021-06-23 View: 1444
During the epidemic, there are many homes and homes, and some details in life may easily cause fires and disasters if you do not pay attention to them. We are reminded to install intelligent smoke alarm. The occurrence of home fires is usually due to the temporary negligence of residents. If we can develop good fire safety habits in our daily life, many fire accidents can be avoided.
[Gas fire prevention]
1, gas leak has a trick, can be coated with soap to see bubbles.
Do not use open flame (matches, lighters, etc.) to find the gas leak, can use the method of observing bubbles with soapy water to find the leak point.
2, liquefied gas bottle temper is big, high temperature exposure will explode.
When using LPG, the cylinder should be kept upright, and should not be heated, baked, shaken, lying down and exposed to the sun to avoid accidents.
3. Illicit backfilling of liquefied gas is too harmful to be banned.
Do not buy illegal liquefied gas, do not dump liquefied gas residual liquid, found secretly filling dens should immediately report to the police.
Electrical fire protection
1, electrical lines need to be protected to prevent leakage and short circuit
Qualified electricians should be invited for household electrical installation. Shred air switches and leakage protectors should be set up on incoming lines. Short circuit protection devices should be set up separately for high-power electrical equipment. Fuses should be selected according to the rated current, do not replace the fuse with copper wire.
2. Wire laying should be standardized, and damaged and aging should be replaced in time
Avoid contact with or close to combustible materials when laying electrical circuits. Avoid line exposure to the sun and rain to make the insulation layer aging; Electrical lines should be protected through pipes, and mechanical damage should be prevented when exposed, and porcelain bushing or steel pipes should be used to protect them when passing through floors or walls.
3, safe use of the terminal board, private pull and buried hidden trouble.
The wiring board should be used to prevent short circuit and fire caused by wear and tear of the insulation part; Frequent movement will make the internal contact of the wiring board loose, causing local overheating; Do not use more than one high-power electrical appliance on the same terminal.
4, power failure do not forget to pull the knife, to prevent electric fire.
After the power failure, to cut off the home power supply, close all electrical switches, to prevent the restoration of power supply electrical equipment due to unattended fire accidents.
[Gas fire prevention]
1, gas leak has a trick, can be coated with soap to see bubbles.
Do not use open flame (matches, lighters, etc.) to find the gas leak, can use the method of observing bubbles with soapy water to find the leak point.
2, liquefied gas bottle temper is big, high temperature exposure will explode.
When using LPG, the cylinder should be kept upright, and should not be heated, baked, shaken, lying down and exposed to the sun to avoid accidents.
3. Illicit backfilling of liquefied gas is too harmful to be banned.
Do not buy illegal liquefied gas, do not dump liquefied gas residual liquid, found secretly filling dens should immediately report to the police.
Electrical fire protection
1, electrical lines need to be protected to prevent leakage and short circuit
Qualified electricians should be invited for household electrical installation. Shred air switches and leakage protectors should be set up on incoming lines. Short circuit protection devices should be set up separately for high-power electrical equipment. Fuses should be selected according to the rated current, do not replace the fuse with copper wire.
2. Wire laying should be standardized, and damaged and aging should be replaced in time
Avoid contact with or close to combustible materials when laying electrical circuits. Avoid line exposure to the sun and rain to make the insulation layer aging; Electrical lines should be protected through pipes, and mechanical damage should be prevented when exposed, and porcelain bushing or steel pipes should be used to protect them when passing through floors or walls.
3, safe use of the terminal board, private pull and buried hidden trouble.
The wiring board should be used to prevent short circuit and fire caused by wear and tear of the insulation part; Frequent movement will make the internal contact of the wiring board loose, causing local overheating; Do not use more than one high-power electrical appliance on the same terminal.
4, power failure do not forget to pull the knife, to prevent electric fire.
After the power failure, to cut off the home power supply, close all electrical switches, to prevent the restoration of power supply electrical equipment due to unattended fire accidents.
